Electro Industries SM1-16 Manual do Utilizador descarregar pdf (Página 34)

Electro Industries/GaugeTech

Doc # E113-7-07 V1.04 3-8

3.5:

Command

Mode

To enter Command Mode from Throughput Mode, send the following escape string:

• [2-second pause]%%%[2-second pause]

• After the last 2-second pause, type H[Enter].

Y Note: This is an actual 2-second pause on either side of the command. The “%” keystrokes must be

made less than two seconds apart.

BE SURE TO USE ALL CAPITAL LETTERS WHEN SENDING COMMANDS TO THE

MULTIPLEXOR; THE UNIT ONLY RECOGNIZES CAPITAL LETTERS.

To begin, type H[Enter]. The following Command Menu appears:

--------------------------------------------

EIG SM Command Mode Commands

H : Display This Menu

HP : Display Port Program Commands

HS : Display Port Status

HU : Display Unit Status

SI : Program Site ID

GT : Go to Throughput Mode

GB : Go to Boot Mode

GM : Go to Mode Selection

PW : Password Protection

EIG : Electro Industries

--------------------------------------------

Commands are listed on the left. Type any command and press Enter. Type H[Enter] at anytime to

access this menu. See the following sections for details about each command.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Sem comentários

Electro Industries SM1-16 Manual do Utilizador Página 34